Course Duration: 8 Hours

Course Price: £165

Qualification: HESA

Course Overview:

This course looks to provide employees working within the Highways Electrical Sector the relevant safety knowledge as well as the practical skills required for work in the vicinity of DNO or IDNO equipment.


This includes overhead power lines and the removal and replacement of DNO or IDNO cut-out fuse carriers in a safe and responsible manner and to comply with the responsibilities under organisation and legislative policies.

Course Content:

  • Overhead and Underground cable accidents
  • Statutory requirements including EAW regulations
  • Highway electrical/domestic System fusing
  • Electricity Distribution network overhead and underground cables
  • Clearances for the Installation and removal of columns/posts
  • The procedure for the Installation and removal of columns/posts near LV and HV overhead cables
  • Clearances to LV overhead cables for maintenance
  • G39 requirements including Electricity supply, pole brackets, maintenance, repair
  • Risk assessments/hazard identification
  • Summative theory assessments
  • Removal and replacement of cut out fuses, practical assessment

Course Objectives:

On completion of the course learners will be able to

  • State the associated Hazards and Risks
  • Specify the acceptable clearances between highway electrical posts/columns and overhead lines
  • State the different methods of providing a mains supply
  • Understand the responsibilities regarding the commissioning, maintenance, repair, and emergency attention
  • State the method of work to be adopted to work in the vicinity of live conductors
  • Knowledge of PPE requirements
  • Demonstrate the ability to correctly remove and replace a cut-out fuse carrier for isolation purposes and replacement of the fuse
  • Carry out a polarity check

Additional Information:

Prerequisites – must have evidence of in date 214 safe isolation certificate or if 214 and 210 running consecutively then learners must pass the 214 before attending 210.

All Learners will be required to fill in the Pre-requisite form before attending the course.

PPE

The Learner is required to bring with them, all required and appropriate PPE that is fit for purpose without defect for the task of safe isolation on an energised system, this includes appropriate electricians’ gloves and face shield.

Materials required

The Learner must also bring with them the following

Non-contact voltage tester

  • Tested and mechanically sound contact electrical tester with leads compliant to GS38
  • A mechanically sound and working proving unit
  • A selection of insulated screwdrivers for tasks

Contact Us

If you are interested in booking a Training Course, please contact us by filling out the booking form below: